PTESENFRDEIT

Violin finger tapes: where each one goes

The distance of each tape from the nut for every violin size, and the safest way to get it right: by listening to the note on a tuner.

Learn violin for free
✓ 100% free✓ no sign-up✓ on your phone and computer✓ the app listens to you play

What finger tapes are for

The violin has no frets: a finger can land anywhere on the fingerboard. At first, thin tapes across the fingerboard show where each finger goes, until the hand learns the spot. They are training wheels: helpful at the start, removed later.

The three first-position tapes

Most beginners use three tapes: finger 1, high 2 and finger 3. On the A string they give B, C♯ and D; on the D string, E, F♯ and G: the notes of the D and A major scales.

EADGfinger 13.6 cmBfinger 26.8 cmC♯finger 38.2 cmDnut
Distances from the nut on a full-size (4/4) violin. In blue, each finger's note on the A string.

Distances from the nut

Always measure from the nut (the small piece where the strings leave toward the pegs), in centimeters. Every violin is slightly different, so use the numbers as a starting point and check by ear.

Violin sizeFinger 1Low 2High 2Finger 3Finger 4
4/43.6 cm5.2 cm6.8 cm8.2 cm10.9 cm
3/43.3 cm4.9 cm6.3 cm7.7 cm10.2 cm
1/23.1 cm4.5 cm5.8 cm7.1 cm9.4 cm
1/42.8 cm4.1 cm5.3 cm6.4 cm8.5 cm
1/82.5 cm3.7 cm4.7 cm5.8 cm7.6 cm

How to place them, step by step

  1. Tune the violin first. With an out-of-tune string, the tape ends up in the wrong place.
  2. Material: 2 to 3 mm wide violin finger tape, or masking tape cut very thin.
  3. Mark with a pencil at the distances in the chart, on the side of the fingerboard.
  4. Check by ear: put finger 1 on the A string and slide slowly until the tuner shows B in the middle. The fingertip sits right over the mark.
  5. Stick the tape under the strings, straight and tight. Repeat for C♯ (finger 2) and D (finger 3).
  6. Finger 4 needs no tape: it must sound the same as the next open string.

When to remove the tapes

Start by looking at the tape and gradually trust your ear more. When your hand finds the spot on its own most of the time, usually after a few months, remove one tape at a time.

The Dedilhado Vivo app has a lesson for this: the microphone listens while you slide your finger and tells you when you reached the tape spot. For the bow, see how to hold and move the violin bow.

Frequently asked questions

Where does the first violin tape go?

On a 4/4 violin, about 3.6 cm (1.4 in) from the nut. That's where finger 1 plays B on the A string.

How many tapes should I put on my violin?

Three to start: finger 1, high 2 and finger 3.

Do the measurements work for any violin?

They're approximate. Check each tape by listening to the note on a tuner.

Free resources

Learn violin for free →